We talk to your BuzzStop over USB to configure it, and phones don't have the right plug or the right browser for that. Hop on a computer with Chrome, Firefox, or Edge and try again.
https://buzzstop.co/setup
Or share this link to yourself: type the URL into your laptop's browser to pick up where you left off.
Live bus arrivals and gentle alerts so you never sprint for a bus again.
Have these three things ready and you're good to go.
Plug BuzzStop into your computer to configure it.
BuzzStop needs Wi-Fi for live arrivals. Enter your network and password below.
Your device is connected to: Unknown (IP: ) (Signal: dBm)
Your device needs Wi-Fi for live arrivals.
Change a setting to see it on the screen below.
Add up to 5 bus stops. BuzzStop cycles through them, showing live arrivals for one at a time.
Search by postal code or use your current location.
Tap a stop to add it to your list.
Enter a postal code or use your current location to find nearby bus stops.
Tap a stop from the results to add it here. Drag a card to reorder.
Search for a stop and tap it, or tap a pin on the map.
BuzzStop can buzz when a specific bus is approaching. Each stop below has its own alerts — add them for your regular routes. Walking times were set with each stop on the previous step.
Pick at least one bus stop first. You'll be able to set alerts here once a stop is chosen.
Your BuzzStop device has been successfully configured.
You can now disconnect your device and it will start displaying bus arrival information.
Connect your device to continue
These settings control a connected device. Connect one to unlock them.
Press Enter to send. Commands go directly to the device.
Device ID
Test mode
Keeps the device awake for inspection. Reboot the device after toggling for the change to fully apply.
Reboot the device after toggling.
Firmware update
Installs the latest BuzzStop firmware straight over this cable. Your Wi-Fi network, bus stop, and alerts are kept.
Takes about a minute. Keep the device plugged in the whole time.
Factory reset
Erases all configuration on the device: Wi-Fi network, bus stops, and alerts. The setup wizard will need to be run again.
This action cannot be undone.
This permanently erases the device's saved Wi-Fi network, bus stops, and alert schedule. You'll need to run the setup wizard from scratch.
Your BuzzStop will reboot after the reset.
Your BuzzStop is running an older version. Updating brings the latest improvements and fixes.
This installs new firmware over the cable. It takes about a minute, and your BuzzStop will restart once partway through, which is normal.